Compact horticultural LED lamp, 54 W, waterproof IP68
This 34 cm horticultural LED lamp packs 150 µmol/s of grow light into a 54 W bar, waterproof up to immersion. It lights a shelf of seedlings, a ledge of herb plants or a small hydroponic tray, with adjustable intensity in steps from 10 to 100%.
The summary
- What you receive: a SANlight STIXX 50 lamp rated at 54 W, its dimmable power supply, the mains cable and two suspension eyelets.
- Its light: a full spectrum from 400 to 780 nm, with a photosynthetic flux of 150 µmol/s.
- The crops: seedlings, cuttings, herbs, salad leaves and one or several small plants.
- The setting: six intensity levels, from 10 to 100%, controlled from the power supply.
- The protection: an IP68-rated lamp, with a power supply to be kept dry and up high.
- The consumption: 0.65 kWh for 12 hours at full power.
LED grow bar for a shelf, seedlings and small indoor plants
The SANlight STIXX 50 is a short bar-shaped grow light, 34 cm long and 8.5 cm wide, which brings together on an aluminium plate the diodes of a complete horticultural light fitting. It consumes 54 W and produces a photosynthetic photon flux of 150 µmol/s, that is, the amount of light plants can actually use for photosynthesis. This compact format makes it suited to small growing spaces: a shelf, a cabinet, the top of a tank or the side of a plant that the window lights poorly. You hang it by its two eyelets, and its separate power supply, connected by a cable of about 2 m, stays away from water and heat.
🌈 The spectrum, from seedling to flowers
The lamp emits from 400 to 780 nm, that is, from deep blue to far red, taking in green and red along the way. This white light, known as full spectrum, covers both foliage growth and flowering, so you keep the same lamp from seedling to harvest. Blue promotes short stems and dense foliage, red supports photosynthesis and flowering, while the green component penetrates deeper between the leaves. Because the light stays white, you see your plants in their true colours, which makes it easier to spot a deficiency, a pest or a yellowing leaf.
Seedlings and cuttings
Under a close, even light, seedlings keep short stems and do not grow leggy as they do beside a window that is too dim.
Aromatic herbs
Basil, parsley or chives grow in tight clumps on a kitchen shelf lit every day.
Salads and shoots
Cut-and-come-again lettuces and microgreen trays produce in the depths of winter under a single light bar.
Supplementary lighting
Placed beside a taller plant, it lights the lower tiers that the main lamp reaches poorly.
🎚️ Intensity adjustable in steps
The power supply provided has a dimmer that sets the output in steps of 10, 20, 40, 60, 80 and 100%. This dimming lets you adapt the light to the stage of the crop without moving the lamp: low intensity for seedlings that have just sprouted, full intensity for mature plants or fruiting vegetables. It also helps correct a lamp placed too close, when the shelf does not leave enough height to raise it. A plant that turns pale or whose leaves curl downwards is getting too much light, whereas a stem that stretches and leans needs more. You read these signs over a few days, then adjust by one step.
Plug the power supply into a timer
A grow light gives its best results when it comes on at the same times every day, for 12 to 16 hours for seedlings and foliage plants. The daily timer plugs in between the socket and the power supply and switches the light back on at the same time each morning, whether you are there or not. Your plants then receive exactly the same dose of light every day, which gives more even germination and steadier growth across the whole shelf.
Waterproof lamp, power supply kept dry
The lamp is waterproof to IP68, but its power supply and mains plug do not have the same protection. Place them high up, away from the beds, tanks and watering splashes, on a socket protected by a 30 mA RCD, and form a drip loop in the cable before the socket, so that a drop running down the wire falls to the floor rather than into the socket. Always unplug the power supply before moving the lamp or cleaning its front face.
The IP68 rating means the lamp itself is fully protected against dust and can withstand prolonged immersion. In a mini greenhouse, above a covered seedling tray or in a very humid grow cabinet, the condensation that settles on the light fitting will not damage it. You can therefore wipe it with a damp cloth to remove dust or traces of grow medium, once the power is disconnected, and place it as close as possible to the plants in a confined environment, between 5 and 35 °C.
📏 The area one light bar covers
The lamp's 150 µmol/s represents all the photons it emits each second, and this light is spread over the surface beneath it. Concentrated on a seedling tray of 60 x 30 cm, or 0.18 m², it could at best deliver around 830 µmol/m²/s there, whereas over a 1 m² shelf it would not exceed 150 µmol/m²/s, since some of the light is always lost at the sides. The further you raise the lamp, the wider the lit area becomes and the lower the intensity reaching each leaf. A single bar is therefore suitable for a tray, a row of pots or a single plant, while a whole shelf calls for two or three bars side by side.
The needs of young plants remain modest: Purdue University considers a daily light integral of 10 to 12 mol/m² sufficient for seedlings intended for transplanting, and Cornell University's controlled environment agriculture group sets the minimum for microgreens at around 12 mol/m² per day. Over 16 hours of lighting, these values correspond to an average intensity of about 175 to 210 µmol/m²/s at leaf level. Over a standard tray, the STIXX 50 therefore provides more than enough, so you start at a low setting after germination and keep full power for adult plants or for a larger area.
🐟 On a small aquaponic system
A small indoor aquaponic system, from the fish tank topped with a grow bed through to the kitchen kit, inevitably places the lamp above water that is constantly evaporating. The STIXX 50 copes with this humid atmosphere, and its length of 34 cm matches the width of a small grow bed. Aim the light at the plants rather than at the surface of the water, because brightly lit water encourages algae in the fish tank. Herbs and salad leaves, which make good use of the nitrogen supplied by the fish, are the crops best suited to this lighting, as the article on herbs in aquaponics explains in detail.
The water in a small aquaponic system is best suited to undemanding crops, as it provides plenty of nitrogen but little potassium and iron. Lettuces, herbs and baby leaves, which produce foliage without flowering, make full use of this water and of the light from a single bar, whereas a tomato would need both more light and additional nutrition. The lamp gives off little heat, which avoids warming the water in a tank of a few dozen litres, where the temperature changes faster than in a large volume. Finally, keep the same lighting hours every day, using the timer, so that the fish and the plants follow a regular rhythm.
🔧 Installation and power consumption
The lamp hangs from its two eyelets, using cables, chains or the LED bar suspension system, which lets you raise it as the plants grow. Its width of 8.5 cm and thickness of 4 cm also allow it to fit under the top shelf of a rack. At full power, it draws 54 W, or about 0.65 kWh for 12 hours of lighting, and less still when you reduce the intensity. To set up a complete station, with heat, humidity and light, the article setting up your indoor seedling area gives the steps in order.
SANlight designs and manufactures its luminaires at its own premises in Vorarlberg, in western Austria. The diodes in the STIXX 50 retain at least 90% of their output after 50,000 hours of operation, which is more than eight years at 16 hours of lighting a day, and the lamp comes with a 3-year guarantee. Its LED modules exceed 3 µmol per joule, so most of the electricity consumed becomes light that is useful to plants. For maintenance, simply unplug the power supply and wipe the front face with a damp cloth when dust or splashes of grow medium dull it.
Technical specifications
The lamp
- Power
- 54 W
- Photosynthetic flux
- 150 µmol/sLight usable for photosynthesis, measured from 400 to 780 nm
- Spectrum
- Full spectrum, 400 to 780 nmFrom growth to flowering
- Dimensions
- 340 x 85 x 40 mm
Electricity
- Dimming
- 10 to 100%, 6 steps10, 20, 40, 60, 80 and 100%
- Lamp-to-power-supply cable
- Around 2 m
- Protection
- IP68Waterproof lamp; power supply kept dry, socket with residual current device
- Weight
- 0.6 to 0.8 kg, 1.4 kg with the power supply
Usage
- Crops
- Seedlings, herbs, salad leaves, small plants
- Mounting
- 2 hanging eyelets
- Lifespan
- 50,000 h at 90% of luminous flux3-year manufacturer's warranty
- Atmosphere
- 5 to 35 °CRelative humidity tolerated up to 99%
To allow for in addition
- Timer
- Daily timerFor a fixed-length day of light
- Suspended
- Suspension systemTo raise the lamp as the weeks go by
6 further specifications are available in the detailed view.
In the box
- 1 SANlight STIXX 50 lamp, 54 W
- 1 dimmable power supply with a European plug
- 1 mains cable for the power supply
- 2 hanging eyelets
Manufacturer's values (product page and STIXX 50 data sheet). Light guidelines: Purdue University and the CEA group at Cornell University.
Manufacturer and product safety
- Website
- www.sanlight.com
Information provided under Regulation (EU) 2023/988 on general product safety.
Documents & manuals
STIXX 50 data sheet
Power, flow, dimming, lifespan, permitted temperatures and humidity, in English and German.
Document not showing? Some publishers block display inside a frame, so open it in a tab.
Estimate your
delivery time
Your estimate
It covers preparing your order and then the transit time quoted by the carrier, counted in working days.
It is not a guaranteed delivery date: public holidays, peak periods, customs or a carrier delay can extend it. The exact amount, in your currency, is worked out in the cart once your address is entered.
The lamp is dispatched in its original box with its power supply, in a parcel of about 1.4 kg from a distributor's warehouse in France. The exact shipping cost is shown in the basket.
Frequently asked questions
10 questions
6 key questions, 10 in the detailed view
You may also like
Let us talk about your project
A question about this product or your setup? Our team will answer and advise you.
Interest-free instalment payments
Offered depending on the cart amount, at checkout.
Delivery in 2 to 15 working days
Depending on the products and shipping sites. Estimate by destination in the estimator on this page.
After-sales service 7 days a week by email or chat
Our team answers all your questions.
Shop responsibly
Become part of the change.










