Indoor hydroponic tower for 30 plants, LED lighting
This vertical growing tower brings its own light: 30 planting positions over 6 tiers, a supporting frame with 4 LED bars, and the submersible pump and its mains adaptor in the box.
It is designed for a kitchen, hallway or office, where the sun does not really reach, and it grows leafy greens and herbs all year round.
The summary
- What you receive: the tower and its 6 tiers, the supporting frame and its 4 LED bars, the 12 V submersible pump with its mains adaptor, a water level indicator.
- How the water circulates: the pump lifts the solution to the top, it flows down tier by tier past the roots, then drops back into the reservoir.
- How much daily effort: a water top-up every 3 to 4 days at full load, a rinse of the circuit between two cycles.
- Where to put it: a room that gets no direct sunlight, where the LED bar replaces the window.
- What it is designed for: leafy greens and herbs, lettuce, rocket, basil, chives, and strawberries.
- What is sent to you: a 63 × 31 × 27 cm box, tower dismantled with its fixings, to a pick-up point or to your door.
Indoor growing tower, 30 slots over 6 tiers, light and pump included
The 30-plant indoor hydroponic tower with LED lighting is used to grow leafy greens and herbs in a room without direct sunlight, such as a kitchen, a hallway or an office. It offers 30 planting positions over 6 levels and supplies its own light, with 4 LED bars. The submersible pump and mains adaptor are included.
This tower holds 30 planting positions over 6 levels and comes with its own lighting. A supporting frame surrounds it and holds 4 vertical LED bars, the submersible pump sits in the 10 L reservoir, and the mains adaptor powers the whole unit. It is designed for a living space where the sun does not come in strongly, such as a kitchen, a hallway or an office.
🔆 The built-in light
The light bar delivers around 2 to 3.6 moles of photons per square metre per day depending on how long it is switched on. A head lettuce needs 11.5 to 17, an indoor basil 8 to 10, and young rocket or mustard shoots 9 to 12. It is therefore a supplement, to be topped up with daylight. Place the tower near a window, even a north-facing one, and you enter the ranges that give firm leaves rather than leggy stems. A duration of 16 hours of lighting per day is the usual setting for leaf crops, and shortening it brings no benefit to the crop.
Lettuce and baby leaves
Their cycle lasts 4 to 6 weeks and you harvest the leaf. Place them on the upper tiers, which get the most light.
Basil
It is a full-sun plant: give it a top tier as well, and pinch it out every week to prolong the harvest.
Parsley, chives, mint
They make do with more moderate light and cope well on the lower levels, where illumination decreases.
Root crops and large fruiting plants
Carrot, beetroot and large-fruited tomato fail: the taproot hits the bottom of the basket, or the plant acts as a lever and snaps.
Fill all 30 positions as soon as it arrives
Order 30 perforated grow pots at the same time, one per position, together with peat germination sponges, which fit directly into them. You sow in the sponges, wait for the roots to show through, then place each sponge in its pot and the pot in the tower. A complete nutrient solution, such as the TriPart Grow growth fertiliser combined with TriPart Micro, then feeds your leaves and herbs from transplanting to harvest.
No potting compost or garden fertiliser in the tower
Do not put potting compost in the pots, as it clogs the tier distributors within a few days. Nor should you use a garden-centre fertiliser designed for soil: it dissolves poorly and does not supply calcium or trace elements in a form that a bare root can absorb. Finally, in a completely windowless room, the light bar alone produces leggy plants with thin leaves, so a window nearby is still necessary.
💧 The gravity-fed cascade
The principle is a gravity-fed cascade. The submersible pump lifts the nutrient solution to the top of the cylinder, the water flows down from tier to tier past the roots, then drops back into the base reservoir. There is no nozzle or misting, and nothing to carry up by hand. Each tier has 5 planting positions around its edge, which gives you 30 plants on a footprint of 39 by 39 cm, roughly that of a large stool. The details of how it works are in the grow tower guide.
🔧 Assembly and filling with water
The tower arrives unassembled, in a box measuring 63 by 31 by 27 cm, with its fixings and assembly instructions. First you assemble the supporting frame and its 4 LED bars, then you stack the 6 growing tiers above the reservoir and fit the top cover. The pump sits at the bottom of the reservoir, connected to the pipe that carries the solution up to the top. Then fill the 10 L, check the level on the indicator, and let the pump run for a few minutes, with the slots still empty, to check that every tier is trickling properly. Once assembled, the tower stands 97 cm tall, frame included: measure the clearance if you plan to put it on a worktop under wall cabinets, and allow for a socket nearby, since the pump and the light bar both need to be plugged in.
🚰 Topping up the water
Once fully grown, 30 lettuces use 2.4 to 3.4 litres per day, which means a top-up every 3 to 4 days at full load. With young plants, consumption is five to ten times lower and the reservoir lasts several weeks. As for electricity, it is the light bar that weighs in, not the pump: expect about 93 kilowatt-hours a year at 16 hours of lighting per day, against 61 for the pump running continuously, and only 15 if you run it for 15 minutes every hour with a daily timer. The noise, finally, comes from the water falling back into the reservoir and not from the pump, which is submersible: it is the sound of a small indoor fountain, constant. Keep the reservoir well filled: the drop height decreases, and the noise with it. Between top-ups, the conductivity of the solution rises as the level falls, since it is the water that evaporates and not the fertiliser: so top up with clean water, and replace the entire solution every 2 to 3 weeks, rinsing the reservoir at the same time.
🐟 Water from a fish pond
This tower can run on pond water, provided three conditions are met, in this order. Filter out solids upstream: a smooth plastic cascade column has no filter mat, and suspended matter settles in the tier distributors until it blocks them. Next, accept a compromise pH: aim for 5.8 to 6.5 in pure hydroponics, 6.4 to 7.5 with fish to look after the bacteria, and at the top of that range iron becomes less available, which a supplementary chelate corrects. Finally, increase the flow rate, which no longer has only to wet the roots but also to sustain nitrification. Then stick to leafy greens and herbs: pond water is low in potassium. The article on aquaponics and hydroponics explains what sets the two methods apart.
Technical specifications
The essentials
- Growing positions
- 30 on 6 levels5 positions per tier, spread around the circumference of the cylinder
- Principle
- Gravity-fed cascadeThe pump lifts the solution to the top and it runs back down in front of the roots. No nozzle, no misting
- Lighting
- LED strip, 4 barsCarried by a frame that surrounds the tower, as a supplement to daylight
- Pump
- Submersible, 12 V, suppliedPlaced in the reservoir with its return pipe
- Feed
- 100 to 240 VMains adapter supplied, European plug, 12 V and 1 A output
- Intended use
- IndoorsIt belongs in a heated, sheltered room, all year round
What light brings
- Light output
- 2 to 3.6 mol/m²/dayDepending on how long it is switched on, from 16 to 24 hours
- Recommended switch-on time
- 16 h per dayUsual setting for leaf crops
- Crops within the range
- Herbs, baby leavesBasil at 8 to 10, rocket and mustard at 9 to 12 moles per day, reached with a little extra daylight
- Crops still to be added
- Round lettuce11.5 to 17 moles per day: a window is needed in addition to the light bar
Footprint, water and consumption
- Overall height
- 97 cmLighting frame included
- Footprint
- 39 by 39 cmFootprint of the supporting frame; the growing cylinder is narrower
- Material
- Food-grade polypropyleneStructure and growing tiers
- Empty weight
- 4.5 kgTower assembled, reservoir empty
- Parcel dimensions
- 63 × 31 × 27 cmThe tower arrives unassembled, with the tiers nested inside the box
- Parcel weight
- 5.2 kgPackaging included, to be allowed for when delivering to a pick-up point
- Reservoir
- 10 LGauge visible on the base, top up without dismantling
- Water consumption
- 2.4 to 3.4 L per day30 full-sized lettuces. Five to ten times as many with young plants
- LED strip light
- approx. 93 kWh per yearAt 16 hours of lighting per day
- Pump
- 15 to 61 kWh per year61 when running continuously, 15 with a timer set to a quarter of an hour per hour
To budget for separately
- Growing baskets
- 30 slotted basketsOne per slot, to hold the sponge and the roots. They are not supplied with the tower
- Germination sponges
- Peat podsOne per basket, to start the seedlings
- Seeds or plants
- Salads and herbsSow in the sponges, then place them in the baskets once the roots have developed
- Nutrient solution
- Growth fertiliser for soilless growingA single complete solution is enough for leafy greens and herbs
16 further specifications are available in the detailed view.
In the box
- 6 stackable growing tiers, with the top lid and the fixings
- 1 support frame and 4 vertical LED bars
- 1 12 V submersible pump, its riser pipe and its mains adaptor
- 1 water level indicator and the assembly instructions
Dimensions, weight and contents of the package recorded on 09/09/2026 and 30/09/2026 from the model's documentation. Light output and consumption: orders of magnitude calculated for a 16 W light bar.
Three towers, three different locations
Choose them according to where you are going to place them, not by the number of holes. The one that supplies its own light is the only one that will cope in a room without direct sunlight.
| A room with no window, south-facing | Balcony, patio or conservatory | Can be moved once filled | Built-in horticultural lighting | Pump | Timer | Slots on the largest model (plants) | Height of the largest model (cm) | |
|---|---|---|---|---|---|---|---|---|
| Recommended Indoor hydroponic tower for 30 plants, LED lightingYour choice | Yes | No | No | Yes | Yes | No | 30 plants | 97 cm |
| Hydroponic growing tower, 20 to 44 plantsYour choice | No | Yes | No | No | No | No | 44 plants | 195 cm |
| Hydroponic system on castors, 56 plantsYour choice | No | Yes | Yes | No | Yes | Yes | 56 plants | 165 cm |
Slots and heights recorded on the three data sheets on 09/09/2026. The modular tower comes in 5, 7 or 11 tiers and the value given is that of the largest.
Help choosing
Three towers, three locations
Estimate your
delivery time
Your estimate
It covers preparing your order and then the transit time quoted by the carrier, counted in working days.
It is not a guaranteed delivery date: public holidays, peak periods, customs or a carrier delay can extend it. The exact amount, in your currency, is worked out in the cart once your address is entered.
Single parcel of 63 × 31 × 27 cm, tower delivered disassembled with its fixings, its pump and its mains adapter. Shipped to a pick-up point or to your home, with the choice made during checkout. The exact cost is shown in your basket.
Frequently asked questions
10 questions
6 key questions, 10 in the detailed view
You may also like
Let us talk about your project
A question about this product or your setup? Our team will answer and advise you.
Interest-free instalment payments
Offered depending on the cart amount, at checkout.
Delivery in 2 to 15 working days
Depending on the products and shipping sites. Estimate by destination in the estimator on this page.
After-sales service 7 days a week by email or chat
Our team answers all your questions.
Shop responsibly
Become part of the change.









