Pack complet TriPart : 4 bidons d'1 L
This pack brings together the three parts of the TriPart system — Grow, Micro and Bloom — in one-litre bottles, along with the pH- adjuster that keeps the solution within the optimal uptake range. It prepares approximately 555 litres of solution at the full growth rate dose, in either soft water or hard water format.
The summary
- What's inside: four one-litre bottles — TriPart Grow, TriPart Micro, TriPart Bloom, and the liquid pH- corrector.
- Which version: soft water below 70 mg of calcium per litre, hard water above. Only the Micro bottle differs.
- What it covers: approximately 555 L of solution at full growth rate, considerably more at gentler stages. One season across several tanks.
- How much to use: 1.8 ml of Grow, 1.2 of Micro, and 0.6 of Bloom per litre during growth. The calculator converts for your reservoir.
- Safety note: Micro is classified H318 and pH- is corrosive H314. Gloves and eye protection when measuring doses.
- Dispatch: approximately 4.8 kg, shipped together in a single parcel from France.
The three TriPart fertilisers and the pH corrector, one litre each
The complete TriPart pack from Terra Aquatica brings together four 1 L bottles, Grow, Micro, Bloom and the pH- corrector, for complete hydroponic nutrition. At the full growth dose, it makes up about 555 L of solution. The Micro is available in a soft water version, below 70 mg of calcium per litre, or a hard water version.
This pack brings together the four one-litre bottles that make up a complete hydroponic nutrient programme: the three parts of the TriPart system, Grow, Micro and Bloom, plus the pH- corrector that keeps the solution in the range where it all remains absorbable. A direct successor to the Flora Series, it is made in Fleurance, in the Gers.
🔢 The order of addition
You fill the reservoir, add each part separately, rinsing the measuring cup between each, mix, and then adjust the pH last with the pH-. The order matters for a precise chemical reason: the calcium in the Micro and the phosphorus in the Bloom, when brought into contact in concentrated form, form an insoluble phosphate that drops to the bottom of the container and can no longer be absorbed. Diluted in the reservoir water, they coexist without any problem. The corrector goes in last because each of the three fertilisers changes the value as it dissolves.
Micro first
It is poured into the reservoir water, with the doser rinsed immediately afterwards. This is the one that carries the calcium.
The Grow, then the Bloom
Each is poured separately, with mixing in between. A concentrate must never be poured directly into another.
pH last
Every fertiliser shifts the pH as it dissolves. Correcting beforehand means correcting twice.
Choosing the Micro version based on your calcium level
Only one bottle differs between the two versions, the Micro: calcium nitrate at 15 to 22.5% for soft water, 5 to 10% for hard water. The benchmark is 70 mg of calcium per litre: below that, choose the soft water version; above it, the hard water version. The total hardness drop test gives you the answer in German degrees, and since 1 °dGH corresponds to 7.1 mg of calcium per litre, water that stays below 10 °dGH suits the soft water version.
The dosage and the two hazard statements
Never pour one concentrate into another, and do not dose with the cap: a volume estimated by eye shifts the concentration of the solution, and the error accumulates with each top-up. The Micro is classified H318, causing serious eye damage, and the pH- is classified H314, corrosive, at pH 1: put on your gloves and goggles when dosing, and rinse for a long time in the event of a splash. The Grow and the Bloom are not classified as hazardous. Once everything is diluted to the working doses, these risks no longer exist.
🧫 The volume of solution covered
The calculation is straightforward: 1,000 ml divided by the dose in millilitres per litre. At the full-growth dose, one litre of Grow gives you 555 litres of solution, one litre of Micro 833 litres and one litre of Bloom 1,666 litres. In pre-flowering, Grow and Micro go up to 2 ml per litre and each covers 500 litres. In flowering, the roles reverse: Bloom goes up to 2.4 ml per litre, so its container covers 416 litres and runs out first.
🪴 The bottle you'll go through first
If you prepare the same volume of solution at each of the five stages, Micro runs out first, though only just, because the sum of its doses across the five stages is the highest of the three: its litre then covers about 158 litres per stage, or nearly 790 litres over the cycle. A 30-litre reservoir renewed every 2 weeks uses 390 litres in 6 months, and the pack comfortably covers that season. In soil, the application chart provides lower doses, for example 1.5 ml of Grow per litre in the growth stage instead of 1.8, which stretches the pack even further. The indoor hydroponics guide helps you size a first reservoir.
🎯 pH and conductivity
The target pH is 5.5 to 6.5 during rooting and growth, then 6.4 to 6.8 in pre-flowering and flowering. For the first addition of pH-down, allow 4 ml per 50 litres of solution, then top up in small doses, measuring as you go. Conductivity is measured afterwards, once the pH has been adjusted: in hydroponics and on coco fibre, it goes from 0.3 to 0.6 mS at the first roots to 1.3 to 1.8 mS in growth, then to 1.8 to 2.0 mS in pre-flowering and 1.4 to 2.2 mS in flowering. If your reading is clearly outside these guidelines, adjust the dose of the three fertilisers rather than that of the corrector.
Technical specifications
What the pack contains
- TriPart Grow
- 1 LNPK 3-1-6. Nitrogen, potassium and magnesium for the vegetative phase. Green liquid, not classified as hazardous.
- TriPart Micro
- 1 LNPK 5-0-1. Calcium, iron and trace elements. Soft-water or hard-water version depending on the pack chosen. Classified H318.
- TriPart Bloom
- 1 LNPK 0-5-4. Phosphorus, potassium, magnesium and sulphur for flowering. Pink liquid, not classified as hazardous.
- pH- corrector
- 1 LNitric, phosphoric and citric acids. Yellowish liquid, pH 1, classified H314.
- Growth dose
- 1,8 / 1,2 / 0,6 ml/LGrow, Micro and Bloom respectively, in hydroponics and on coco fibre. In soil: 1.5 / 1 / 0.5 ml/L.
- Target pH
- 5.5 to 6.5During rooting and growth, then 6.4 to 6.8 at pre-flowering and flowering stages.
To budget for separately
- pH measurement
- Drop test kit or pH meterWithout a measurement, the pH- bottle is dosed blind. The drop test requires no calibration and is perfectly adequate to start with.
- Graduated measure
- Syringe or measuring cylinderDoses range from 0.5 to 2.4 ml per litre, that is 10 to 48 ml for a 20-litre reservoir.
- Conductivity meter
- A probe meterIt shows that a reservoir is concentrating through evaporation, or that a solution has become too dilute, before the plant shows any signs.
- Rinsing container
- A dedicated glass of clean waterPlaced beside the reservoir, it lets you rinse the dispenser between uses without going back to the sink.
2 further specifications are available in the detailed view.
In the box
- 1 container of TriPart Grow (1 L).
- 1 container of TriPart Micro 1 L, in soft water or hard water version depending on the pack chosen.
- 1 container of TriPart Bloom 1 L.
- 1 container of liquid pH- corrector of 1 L.
NPK formulas taken from product labels; dosages, pH and conductivity values: 2025 application table. H318 and H314 classifications: French safety data sheets dated 25/07/2024 and 22/11/2023. Pack assembled by the shop from the four references, in their original packaging.
Manufacturer and product safety
- Manufacturer
- TERRA AQUATICA (SAS, SIREN 840329619), ex General Hydroponics Europe
- Postal address
- 4 boulevard du Biopole, ZI du Biopole, 32500 Fleurance, France
- Contact
- info@terraaquatica.com ; +33 5 62 06 08 30
- Website
- www.terraaquatica.com
Information provided under Regulation (EU) 2023/988 on general product safety.
What each of the four bottles in the pack does
Three fertilisers and a pH corrector. This table explains what each one provides, when it is dominant, and which ones require gloves.
| TriPart GrowYour choice | TriPart MicroYour choice | TriPart BloomYour choice | pH- correctorYour choice | |
|---|---|---|---|---|
| Formula declared on the label | ||||
| Total nitrogen (%) | 3 % | 5 % | 0 % | 0 % |
| Phosphorus, P2O5 (%) | 1 % | 0 % | 5 % | 0 % |
| Potassium, K2O (%) | 6 % | 1 % | 4 % | 0 % |
| Supplies calcium and iron | No | Yes | No | No |
| That is what changes between the two versions of the pack | No | Yes | No | No |
| Hydroponic dosage, millilitres per litre | ||||
| First roots (ml/L) | 0,5 ml/L | 0,5 ml/L | 0,5 ml/L | 0 ml/L |
| Full growth (ml/L) | 1,8 ml/L | 1,2 ml/L | 0,6 ml/L | 0 ml/L |
| Flowering (ml/L) | 0,8 ml/L | 1,6 ml/L | 2,4 ml/L | 0 ml/L |
| Fixed dose per litre | Yes | Yes | Yes | No |
| Use and safety | ||||
| Present at a high dose at every stage | No | Yes | No | No |
| Classified hazardous | No | Yes | No | Yes |
| Gloves and goggles when measuring | No | Yes | No | Yes |
| Liquid colour | Green | Dark brown | Pink | Yellowish |
| Added last | No | No | No | Yes |
Formulas taken from the bottle labels; doses from the 2025 application chart, hydroponics and coco fibre column; values checked on 10/09/2026.
Help choosing
Which bottle to start with
Documents & manuals
TriPart application chart, hydroponics, coconut fibre and soil, multilingual document
The official stage-by-stage table, in millilitres per litre for the three fertilisers in the pack, with the target conductivity and pH ranges. French and English appear side by side.
Safety data sheet for TriPart Micro freshwater, in French
Version 9, dated 25 July 2024. H318 classification, declared composition and protective equipment to be worn when measuring doses.
Safety data sheet for pH- corrector, in French
Version dated 22 November 2023. H314 classification, orthophosphoric acid content and steps to follow in the event of contact.
Safety data sheet for TriPart Micro freshwater, in English
Version 9 dated 25 July 2024, same content as the French data sheet: H318 classification, declared composition and mandatory eye protection during dosing. Document in English.
Safety data sheet for TriPart Micro Hard Water, in English
Version 9 dated 25 July 2024, for the hard water version of the pack. Same H318 classification. Document in English.
Safety data sheet for TriPart Grow, in English
Version 8, dated 25 July 2024. This container is not classified as hazardous: only precautionary statements P101 and P102 appear on the label. Document in English.
Safety data sheet for TriPart Bloom, in English
Version 7 dated 26 December 2023, for the third fertiliser in the pack. Product not classified as hazardous, with the same precautionary statements P101 and P102. Document in English.
Safety data sheet for pH- corrector, in English
Version 8 dated 22 November 2023, for the fourth container in the pack. H314 classification, orthophosphoric acid content and action to take in the event of contact. Document in English.
Document not showing? Some publishers block display inside a frame, so open it in a tab.
Estimate your
delivery time
Your estimate
It covers preparing your order and then the transit time quoted by the carrier, counted in working days.
It is not a guaranteed delivery date: public holidays, peak periods, customs or a carrier delay can extend it. The exact amount, in your currency, is worked out in the cart once your address is entered.
Four one-litre bottles shipped together, approximately 4.4 kg, by tracked parcel from France: a single shipment instead of four. None of the four is classified as dangerous for transport, despite the H318 and H314 statements, which relate to handling. The exact shipping costs are displayed at checkout once your address has been entered.
Frequently asked questions
8 questions
6 key questions, 8 in the detailed view
How much TriPart Grow for your reservoir
Enter the volume of water in your reservoir. The calculator applies the full-growth dose for Grow, 1.8 ml per litre. Micro and Bloom are dosed in parallel, at 1.2 and 0.6 ml per litre at the same stage.
of TriPart Grow, full growth-stage dosage in hydroponics and on coco fibre
Full doses for hydroponics and coco fibre, in millilitres per litre, in the order Grow, Micro, Bloom: first roots 0.5 / 0.5 / 0.5; first true leaves 1 / 1 / 1; growth 1.8 / 1.2 / 0.6; pre-flowering 2 / 2 / 1.5; flowering 0.8 / 1.6 / 2.4. In soil, use the dedicated column of the table: 0.2 ml per litre of each part at the first-roots stage, then 1.5 / 1 / 0.5 in growth and 0.7 / 1.4 / 2.1 in flowering. The pH- is added last, with no fixed dose: it depends on the buffering capacity of your water.
You may also like
Let us talk about your project
A question about this product or your setup? Our team will answer and advise you.
Interest-free instalment payments
Offered depending on the cart amount, at checkout.
Delivery in 2 to 15 working days
Depending on the products and shipping sites. Estimate by destination in the estimator on this page.
After-sales service 7 days a week by email or chat
Our team answers all your questions.
Shop responsibly
Become part of the change.









